How To Ensure Stable Storage Of 304 Stainless Steel Plate

304 stainless steel plate passes through the cutting part of the rough embryo of seamless steel pipe, and then it is heated, perforated, sized, straightened and cooled. Moreover, the filler at the top of the head in the circular furnace becomes a finished product up to the standard, which can not be used in the factory in manufacturing. In a large number of areas, agents must give some points, but agents usually do not have large and medium-sized in room public libraries, and some public libraries are excessively expensive and uneconomical. Most of them are outdoor warehouses, and 304 stainless steel plates are placed outdoors to prevent direct sunlight.

304 stainless steel plate will have a certain storage time after production or purchase. So, how to store to ensure reliability?

1. Maintain the surface or warehouse cleaning of 304 stainless steel plate commodities, and avoid the mining of factories and mines with toxic gas or dust. Weeds and all dirt need to be removed from the site to maintain the cleaning of stainless steel plates.

2. Do not accumulate corrosive raw materials in the warehouse, such as acid, alkali, salt or concrete. Different types of steel shall be stacked separately to avoid mixing and contact erosion.

3. Large, medium and small seamless steel pipe, steel wire, medium diameter seamless steel pipe, steel wire, galvanized steel wire rope, etc. can be stored in a shed with good air circulation, but must be placed below.

4. Some small steel, thin steel, steel, silicon steel, small diameter or thick wall steel, all kinds of hot rolled and cold drawn steel products and their high price and corrosive metal products can be stored in the warehouse.

5. Large and medium-sized section steel, train track, insult steel, large-diameter seamless pipe, steel castings, etc. can be stacked outdoors.

Clean the 304 stainless steel plate with tap water and then go offline. However, after high temperature heating, the temperature of 304 stainless steel plate after water cooling and heat dissipation is still high. Therefore, 304 stainless steel plate without mesh in summer should pay attention to the following aspects:

1. Remove the 304 stainless steel plate from the steel wire, place it in a flat area, and then place it. You don't have to squeeze each other. If the extrusion is placed for less than 24 hours, the PE layer shall be completely adhered to the outer and inner wall of the seamless steel pipe.

2. 304 stainless steel plate does not need rainy days without mesh. It is very easy to cause leakage of tee joint after raining.

3. During the production of 304 stainless steel plate, the epoxy resin adhesive powder and adhesive shall be 1% larger than usual to achieve the specific thickness.

4. After exiting, do not expose 304 stainless steel plate to continuous high temperature. Exposure is very easy to cause the PE layer to swell, and then the surface of seamless steel pipe falls off, so it is impossible to achieve the anti rust effect.